Comp,SS,Stocker parts

[Jeff Lee]

Originally Posted by Dwight Southerland

.866" dia 2.000" long. JE's pn tells the size.

Ok, now I know! To small & too short then.

[Rick Leininger Jr.]

Originally Posted by Jeff Lee

Ok, now I know! To small & too short then.

You might be surprised how much hp a small and short quality pin can handle these days. I'd put either of these .866" pins in any big hp small block comp motor, in a traditional small block SS motor I'd go a lot smaller.

[Jeff Lee]

Originally Posted by Rick Leininger Jr.

You might be surprised how much hp a small and short quality pin can handle these days. I'd put either of these .866" pins in any big hp small block comp motor, in a traditional small block SS motor I'd go a lot smaller.

I agree and would buy them but the pistons are set for a 2.750" x .927". Cylinder bore is 4.230"