|
|
08-22-2021, 07:25 PM
|
#14 |
|
Live Reporter
Join Date: Oct 2004
Location: Hickory, Ky
Posts: 10,646
Likes: 1,941
Liked 10,746 Times in 2,235 Posts
|
Re: Micro Welding of bearing shell to rod housing bore
Yes Ray the cable is connected to the block. I never considered an arcing or plating situation
Not sure on cycles on rods or bolts. Bolts are ARP 7/16 20NF 12 point. The big end of the rod stays rounder longer since we installed a clean neutral valve body in the trans. I use the brakes to stop the car without compression braking. Last edited by Larry Hill; 08-22-2021 at 07:27 PM. |
|
|
| Liked |
|
|
Threaded Mode