|
![]() |
#1 |
Member
Join Date: Dec 2009
Location: Kingman, NW AZ. in the middle of the longest stretch of Route 66
Posts: 308
Likes: 0
Liked 17 Times in 13 Posts
|
![]()
put on a set of Cal-Tracs. need to know what is the best pinion angle?
Specs. 56 Nomad, leaf springs [6 'cause its a wagon] spring pads are 6" long. 9/16" U-bolts. approx. 1725lbs on rear. motor mounted solid, so the trans angle is NOT adjustable. right now the 4speed to 'shaft is 2degrees. the pinion is about 1/2degrees up from level and there is 2 degrees difference. I have degrees shims. if I put the pinion down -2degrees, that would make 4 degrees total at the rear. setting the front would change very little. at launch, the front angle should increase approx 2 degrees [front/body rise]. in high gear the front drops down. in theory then, the front angle would be 2+ degrees difference and the rear would be 2 1/2 degrees the opposite direction. sound right or no? with the long spring pads, I cant see the pinion turning up very much. 6degrees down would be a lot, I think! thoughts? thanks Rod in AZ |
![]() |
![]() |
Liked |
|
|