|
![]() |
#11 |
VIP Member
Join Date: Jul 2008
Location: Liberty City [East Texas]
Posts: 1,760
Likes: 5
Liked 99 Times in 60 Posts
|
![]()
Stan,
1982 Camaro Berlinita
__________________
Larry Woodfin 471W |
![]() |
![]() |
![]() |
#12 |
Member
Join Date: Oct 2009
Location: columbus, georgia
Posts: 385
Likes: 65
Liked 309 Times in 88 Posts
|
![]()
An 1/8th mile bracket car will only be on the track for six seconds or so and a large portion of the run will be at a much lower speed than finish line speed which would make aerodynamics less important. I agree with Lee.
|
![]() |
![]() |
![]() |
#13 |
VIP Member
Join Date: Dec 2001
Location: phoenix
Posts: 1,486
Likes: 66
Liked 704 Times in 281 Posts
|
![]()
I think 80's Monte Carlo with SS nose has CD of .34.
Question: If a car has more downforce then lift would go be faster if they were made equal? Last edited by Jeff Stout; 08-07-2020 at 04:01 PM. Reason: more |
![]() |
![]() |
![]() |
#14 |
Member
Join Date: Jan 2016
Location: Colorado hills
Posts: 123
Likes: 11
Liked 73 Times in 36 Posts
|
![]()
When considering aerodynamics of drag racing cars/trucks, etc. The assumption of aerodynamic drag only has an effect at speed is incorrect.
![]() ![]() ![]() Regards, HB2 ![]() Dissident |
![]() |
![]() |
![]() |
#15 |
VIP Member
Join Date: Jun 2006
Posts: 3,416
Likes: 521
Liked 330 Times in 178 Posts
|
![]()
also tire width ,fender flares, ground effects ,spoilers, unnecessary openings in the grille area, upward lift attitude of the front end at speed as opposed to downward attitude--elimination of any unnecessary body parts ( mirrors etc.) ---all these affect airflow over under and around the vehicle ---You want to make the vehicle silohuette as smooth as possible ( within any rules restrictions course)--as vehicle speed increases it becomes of paramount importance to consider all of these----look at a jellybean as opposed to a brick and or a Corvette vs. a Van and you will get the idea--- modern auto manufacturers go to great lengths in "styling" their products not only for looks but to achieve the tinyest of drag reductions to increase fuel mileage
|
![]() |
![]() |
![]() |
#16 |
Senior Member
Join Date: Jan 2008
Location: 100th Meridian
Posts: 569
Likes: 116
Liked 280 Times in 139 Posts
|
![]()
I remember reading an article by Lingenfelter back in the early 70's.On his S/S 69 Camaro rag the car picked up a bit of MPH using only the front spoiler,and lost using the rear.The car would MPH around 115.In those days you would have to run both (as part of the SS package) or none at all.On my '71 it picks up about a 1/2 a MPH (more in a strong headwind) with the front spoiler...gsa612
Last edited by gsa612; 08-08-2020 at 12:37 PM. |
![]() |
![]() |
![]() |
#17 |
Senior Member
Join Date: Sep 2010
Location: Houston,Texas
Posts: 819
Likes: 3,498
Liked 640 Times in 192 Posts
|
![]()
Larry I ran a 82 z28 with the ground effects and I had a large rear deck wing, car was very stable at 185 mph in 1/4 mile..LOL
|
![]() |
![]() |
![]() |
#18 |
Junior Member
Join Date: Jul 2020
Posts: 12
Likes: 31
Liked 12 Times in 7 Posts
|
![]()
On a 79 Malibu wagon the factory rear spoiler is worth almost 3mph on car that runs just at 100 without it in the quarter.. and the reason for it is that it pulls air from the roof and routes it down the back window (to keep it clean in civilian life) which fills in the vacuum hole behind the car. and if you're wondering how big and powerful that "vacuum hole" is, it is what the cars that make turns use to create their ground effects downforce in sufficient quantities to be able to drive one across the ceiling upside down. The "vacuum hole" is also the reason behind drafting in nascar, if you can get in close enough it will damn near pull you along... need proof of what good aero can do? How about 174 on a bicycle...peddling.
what you really want to do with the front of the car is to smooth the air and keep it out from under the car, along the sides and roof you need to keep it flowing smoothly, and a the back you need to eliminate the "vacuum hole"... Jackie |
![]() |
![]() |
Liked |
![]() |
#19 |
Member
Join Date: Jul 2016
Posts: 389
Likes: 1,655
Liked 753 Times in 213 Posts
|
![]()
You will find here 2 articles to add more details to this post.
https://www.scientificamerican.com/a...es-in-golf-ba/ https://www.grc.nasa.gov/WWW/K-12/ai.../boundlay.html I also like the FED387 informations regarding the one hand out of a car test... (relate to the coefficient of aerodymanic when the front of the car is more up in the air) Enjoy, Charles Stewart |
![]() |
![]() |
![]() |
#20 |
VIP Member
Join Date: Jul 2008
Location: Liberty City [East Texas]
Posts: 1,760
Likes: 5
Liked 99 Times in 60 Posts
|
![]()
The above post gave me the idea to cover the surface of my Camaro with dimples. Maybe use a small ball pien hammer or leave it outside in a Texas hail storm.
__________________
Larry Woodfin 471W |
![]() |
![]() |
Liked |
![]() |
|
|