Rons Porting Service Brodix 10 Heads

KUYKRACING · 05-30-2008, 01:34 PM

Fully ported for competition eliminator. With matching intake manifold.
Brodix 10 aluminum heads, flow 320/234 @.700"lift. 232 cc intake runners, 51 cc chambers. Titanium retainers, new 10 degree Manley valve locks, K Motion 1.625" roller springs set at 1.95" installed height and 250# seat pressure, with spring cups. Titanium 2.080"/ 1.60" 11/32" stems. T&D shaft rockers 1.6 offset intake, 1.5 exhaust. Matching fully ported intake, 4150 flange. All done by Rons Porting Service of St. Louis. Standard exhaust bolt pattern. These heads have very limited run time on them and have been freshly assembled.
Heads new were $1200. Porting was $1000, Valves were $1600, springs were $250, Retainers and locks were $175 rockers were $1200. Intake was $650 ported. Add it up.

05-30-2008, 01:34 PM	#1
KUYKRACING Junior Member Join Date: May 2008 Posts: 4 Likes: 0 Liked 0 Times in 0 Posts	Rons Porting Service Brodix 10 Heads Fully ported for competition eliminator. With matching intake manifold. Brodix 10 aluminum heads, flow 320/234 @.700"lift. 232 cc intake runners, 51 cc chambers. Titanium retainers, new 10 degree Manley valve locks, K Motion 1.625" roller springs set at 1.95" installed height and 250# seat pressure, with spring cups. Titanium 2.080"/ 1.60" 11/32" stems. T&D shaft rockers 1.6 offset intake, 1.5 exhaust. Matching fully ported intake, 4150 flange. All done by Rons Porting Service of St. Louis. Standard exhaust bolt pattern. These heads have very limited run time on them and have been freshly assembled. Heads new were $1200. Porting was $1000, Valves were $1600, springs were $250, Retainers and locks were $175 rockers were $1200. Intake was $650 ported. Add it up.