ET Drag Radials Spinning On Wheels

Chad E532 · 08-30-2009, 09:10 PM

Today I made the first passes on a new set of 30x9x15 M/T ET Drag radials and after a couple runs I looked at the paint marks I had put on the tires to indicate where the valve stems were and I found that the LH tire had moved about 2 1/2" and the RH about 1". I was running 20psi in the radials so I am pretty surprised that they are spinning on the wheels.

Can a person install rim screws on a tubeless tire without leak issues?

Are there any other methods that do not require drilling holes in the rims?

Thanks in advance!
Chad

08-30-2009, 09:10 PM	#1
Chad E532 Member Join Date: Jul 2008 Location: Lindstrom MN Posts: 156 Likes: 7 Liked 54 Times in 7 Posts	ET Drag Radials Spinning On Wheels Today I made the first passes on a new set of 30x9x15 M/T ET Drag radials and after a couple runs I looked at the paint marks I had put on the tires to indicate where the valve stems were and I found that the LH tire had moved about 2 1/2" and the RH about 1". I was running 20psi in the radials so I am pretty surprised that they are spinning on the wheels. Can a person install rim screws on a tubeless tire without leak issues? Are there any other methods that do not require drilling holes in the rims? Thanks in advance! Chad

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode