CLASS RACER FORUM - View Single Post - A-Body mopar guys: Where do you guys get your headers from without going custom?

mike natoli · 12-09-2008, 04:48 PM

Jeff,
I had a set of the stepped 1 17/8 - 2" 3 1/2" collector Hedman headers built by I believe Phil? His brother is a member of this site. Did a great job bending welded flange, fit great and reasonably priced compared to a custom built. I will venture to say they are custom. Now I'm in the midst of building my son a small block duster would like to have him put another set together for me. These were slip together one out each fender well and just a little clearance problem with a 28" tall front tire. Is this the same person and if so can you email his number at Hedman to me. They look great coated and also had the evacuation tubes the one thing I will do on this set is have O2 sensor bungs installed before coating.
Best Regards,
Mike

12-09-2008, 04:48 PM	#12
mike natoli Member Join Date: Mar 2007 Location: Valley Stream mini Gasoline Alley & Div I Posts: 100 Likes: 25 Liked 52 Times in 16 Posts	Re: A-Body mopar guys: Where do you guys get your headers from without going custom? Jeff, I had a set of the stepped 1 17/8 - 2" 3 1/2" collector Hedman headers built by I believe Phil? His brother is a member of this site. Did a great job bending welded flange, fit great and reasonably priced compared to a custom built. I will venture to say they are custom. Now I'm in the midst of building my son a small block duster would like to have him put another set together for me. These were slip together one out each fender well and just a little clearance problem with a 28" tall front tire. Is this the same person and if so can you email his number at Hedman to me. They look great coated and also had the evacuation tubes the one thing I will do on this set is have O2 sensor bungs installed before coating. Best Regards, Mike