View Single Post
Old 10-08-2008, 07:11 PM   #2
SSDiv6
VIP Member
 
Join Date: Feb 2003
Location: Glendale, Arizona
Posts: 3,044
Likes: 712
Liked 1,585 Times in 582 Posts
Default Re: engine test run stand

Quote:
Originally Posted by Dragsinger View Post
I plan to build a test stand to accommodate a SBC or BBC and also bolt up a powerglide as a way to load the engine. Not to test wide open against the converter but simply a light, varying load for a short time. To lock the Glide I am considering a driveshaft yoke without u-joint then pass a piece of solid rod through the yoke. The rod would have some type of secure catch.

Let me have your photos and thoughts.

Thanks
Why??? Too dangerous. The set up would require to be built to restrain lots of loading from the torque of the engine. If you add up the cost of building such a set up, and the amount of use, you would do more by spending the money at a reputable dyno facility.
SSDiv6 is offline   Reply With Quote