CLASS RACER FORUM - View Single Post

hbr509 · 08-14-2023, 06:24 AM

Good thoughts guys but shocks in front are lakewood 90/10 and are fine , also the trans has been changed also I have 2 each time and same results , I bought a new front pump from Abruzzi and input shaft still the same, I went to Bradenton last friday with the PTC tighten 500 rpm according to race pak and same results 1.38v 60ft 6.10 et and no rotation on front , I am pulling motor and sending back to Nesbitt for check and freshen up . This is the only thing I have not done yet . I have changed the distributer,coil,msd box you name it its been changed lol. I,m tired Thanks For your help .will keep posted when the motor comes back .

08-14-2023, 06:24 AM	#12
hbr509 Junior Member Join Date: Jul 2023 Posts: 4 Likes: 0 Liked 3 Times in 2 Posts	Re: Convertor help Good thoughts guys but shocks in front are lakewood 90/10 and are fine , also the trans has been changed also I have 2 each time and same results , I bought a new front pump from Abruzzi and input shaft still the same, I went to Bradenton last friday with the PTC tighten 500 rpm according to race pak and same results 1.38v 60ft 6.10 et and no rotation on front , I am pulling motor and sending back to Nesbitt for check and freshen up . This is the only thing I have not done yet . I have changed the distributer,coil,msd box you name it its been changed lol. I,m tired Thanks For your help .will keep posted when the motor comes back .