CLASS RACER FORUM - View Single Post - Micro Welding of bearing shell to rod housing bore

Larry Hill · 08-22-2021, 07:25 PM

Yes Ray the cable is connected to the block. I never considered an arcing or plating situation
Not sure on cycles on rods or bolts. Bolts are ARP 7/16 20NF 12 point. The big end of the rod stays rounder longer since we installed a clean neutral valve body in the trans. I use the brakes to stop the car without compression braking.

08-22-2021, 07:25 PM	#6
Larry Hill Live Reporter Join Date: Oct 2004 Location: Hickory, Ky Posts: 10,640 Likes: 1,937 Liked 10,712 Times in 2,230 Posts	Re: Micro Welding of bearing shell to rod housing bore Yes Ray the cable is connected to the block. I never considered an arcing or plating situation Not sure on cycles on rods or bolts. Bolts are ARP 7/16 20NF 12 point. The big end of the rod stays rounder longer since we installed a clean neutral valve body in the trans. I use the brakes to stop the car without compression braking. __________________ IHM Used Parts https://ihmusedparts.com 888-821-1817 Last edited by Larry Hill; 08-22-2021 at 07:27 PM.