CLASS RACER FORUM - View Single Post - Micro Welding of bearing shell to rod housing bore

pmrphil · 08-22-2021, 09:32 AM

I don't know if it's correct or not, but I use a height gauge to measure each shell and to verify that the shells are square, which I've found some that are way off. I've had rods on the small end of spec as well as the big side both do it.

08-22-2021, 09:32 AM	#1
pmrphil Member Join Date: Aug 2010 Location: CT Posts: 456 Likes: 1,796 Liked 346 Times in 150 Posts	Re: Micro Welding of bearing shell to rod housing bore I don't know if it's correct or not, but I use a height gauge to measure each shell and to verify that the shells are square, which I've found some that are way off. I've had rods on the small end of spec as well as the big side both do it. __________________ Phil Molski PMR Performance S/C 1623