CLASS RACER FORUM - View Single Post

Patric Fox · 12-23-2020, 01:13 PM

I have the same issue with a block I had to the machine shop, sat around in my garage for too many years. Now I have a little time, pulled it off the shelf and the WD-40 I sprayed on it to keep it from rusting dried on the cylinder walls. Recleaned it, and didn't like the look of the cylinders.Started checking clearences, and the piston to cylinder wall measurement isn't to my specs. So I am going so send it out to get rehoned again.

12-23-2020, 01:13 PM	#7
Patric Fox Member Join Date: Jul 2007 Location: Pottstown,Pa. Posts: 121 Likes: 24 Liked 11 Times in 8 Posts	Re: cylinder wall finish I have the same issue with a block I had to the machine shop, sat around in my garage for too many years. Now I have a little time, pulled it off the shelf and the WD-40 I sprayed on it to keep it from rusting dried on the cylinder walls. Recleaned it, and didn't like the look of the cylinders.Started checking clearences, and the piston to cylinder wall measurement isn't to my specs. So I am going so send it out to get rehoned again.