CLASS RACER FORUM - View Single Post

Hacksaw · 09-12-2017, 04:22 PM

I went off the end at Martin about 10 years ago. Frightening to say the least. My fix was to form a "top hat" from heavy sheet metal flat bar with the two outer holes matching the master cyl mounting holes and a center clearance hole for the pushrod to go through. After a mockup, I marked the exact spot for a flat washer to get welded on the rod, on the cyl side of the "top hat" with a slight amount of clearance. Simple and works.

09-12-2017, 04:22 PM	#12
Hacksaw Senior Member Join Date: Sep 2016 Posts: 882 Likes: 206 Liked 310 Times in 174 Posts	Re: S/SS Brake safety I went off the end at Martin about 10 years ago. Frightening to say the least. My fix was to form a "top hat" from heavy sheet metal flat bar with the two outer holes matching the master cyl mounting holes and a center clearance hole for the pushrod to go through. After a mockup, I marked the exact spot for a flat washer to get welded on the rod, on the cyl side of the "top hat" with a slight amount of clearance. Simple and works.