CLASS RACER FORUM - View Single Post - Jerico DR4, Aluminum Driveshaft, and M/T Slicks

T-Bolt Racer · 11-26-2014, 10:57 AM

Is this jerico a mag case or a Alum?

Jerico DR4. Gear ratio stamped on case show 3.19, 2, 1.39, 1. Long pistol grip shifter. 1 3/16" 18 spline mopar input shaft for stock chevy depth bellhousing. Approximately 60 runs since last service.
Asking $2,600 shipped

Aluminum driveshaft that fit the Jerico in a 1994 Camaro.
Asking $300 shipped

M/T Slicks Part #3056ST. Approximately 20 runs
Asking $300 shipped

Pictures available.

Please call at 614-499-3717 or email brian.erwin7@gmail.com

Thank you,

Brian Erwin[/QUOTE]

11-26-2014, 10:57 AM	#3
T-Bolt Racer Junior Member Join Date: May 2013 Posts: 57 Likes: 0 Liked 0 Times in 0 Posts	Re: Jerico DR4, Aluminum Driveshaft, and M/T Slicks Is this jerico a mag case or a Alum? Jerico DR4. Gear ratio stamped on case show 3.19, 2, 1.39, 1. Long pistol grip shifter. 1 3/16" 18 spline mopar input shaft for stock chevy depth bellhousing. Approximately 60 runs since last service. Asking $2,600 shipped Aluminum driveshaft that fit the Jerico in a 1994 Camaro. Asking $300 shipped M/T Slicks Part #3056ST. Approximately 20 runs Asking $300 shipped Pictures available. Please call at 614-499-3717 or email brian.erwin7@gmail.com Thank you, Brian Erwin[/QUOTE]