CLASS RACER FORUM - View Single Post

Alan Nyhus · 01-04-2014, 11:39 PM

Rich, the round stock is 3/4". With a .750 counterbore, I went .125 deep in the plates as a register for the round stock, faced off the ends of the round in my lathe, drilled and tapped the ends of the round 1/4X20 and used a standard 82 degree countersink for the flat head Allen screws. You could also just have it TIG'd and simplify the deal.

Took longer to clean up the chips than make the part. Not really....... -Al

01-04-2014, 11:39 PM	#3
Alan Nyhus VIP Member Join Date: Dec 2002 Location: Lower Dakota territory Posts: 1,180 Likes: 1,074 Liked 799 Times in 236 Posts	Re: Nova stocker project. Rich, the round stock is 3/4". With a .750 counterbore, I went .125 deep in the plates as a register for the round stock, faced off the ends of the round in my lathe, drilled and tapped the ends of the round 1/4X20 and used a standard 82 degree countersink for the flat head Allen screws. You could also just have it TIG'd and simplify the deal. Took longer to clean up the chips than make the part. Not really....... -Al __________________ "That'll never work....." Last edited by Alan Nyhus; 01-04-2014 at 11:41 PM.