CLASS RACER FORUM - View Single Post - SB Mopar 60767 Edelbrock head

magnumv8 · 12-09-2013, 06:20 PM

What you are looking at is that Edelbrock has the heads set up for their on finished product.....you would need to enlarge the guides for your 3/8 valve stems which wouldn't be too difficult but, the question would be if there is enough valve seat material in the seat insert to get a 1.88" valve properly seated with your competition valve job......I have a set of the 61767 Magnum heads done and the seats that were in the heads had just enough for the factory Magnum 1.92" valve. Edelbrock installs inserts set up for a 2.02" intake valve...........

D L Rambo......Stk 1300

12-09-2013, 06:20 PM	#4
magnumv8 Member Join Date: Feb 2009 Location: Coraopolis, Pa. Posts: 172 Likes: 0 Liked 0 Times in 0 Posts	Re: SB Mopar 60767 Edelbrock head - Question What you are looking at is that Edelbrock has the heads set up for their on finished product.....you would need to enlarge the guides for your 3/8 valve stems which wouldn't be too difficult but, the question would be if there is enough valve seat material in the seat insert to get a 1.88" valve properly seated with your competition valve job......I have a set of the 61767 Magnum heads done and the seats that were in the heads had just enough for the factory Magnum 1.92" valve. Edelbrock installs inserts set up for a 2.02" intake valve........... D L Rambo......Stk 1300