CLASS RACER FORUM - View Single Post - Chevy EFI

Angelo DiTocco · 08-30-2012, 08:19 PM

083 castings (not the later model leakers)
Completely updated w/ Brand New valves, etc..
heads were used one season
Ran 9.90s in GT/GA in bracket mode w/ bias tires, 20w-50 oil...before the updates!
There's a lot left with the updates and a 21st century short-block (honda rods / gun drilled crank...etc)
These are as good as new and have been proven to not leak.
Can be run as a dish combo at 265hp or as a flat top at 270hp.
Prob the best 350 chevy combo out there
Also have matching Hughes Sheet Metal Intake
Will include EFI programming to the buyer.
This set-up would cost $11-$12K (maybe more)
I'm asking $7000 for everything, complete ready to bolt on.
A short-block is also available (only 80 runs since new) that these heads would bolt right on - Bow-Tie Block / Splayed Caps / Chevy Steel Crank (stroked & lightened but NOT gundrilled) / BME 2-Ring Pistons / Manley Rods / Jesel Belt / Big Pan / Comp Cam / ATI Balancer / etc. Obviously it should be freshened - honed / rings / bearings..... thats it

08-30-2012, 08:19 PM	#1
Angelo DiTocco Senior Member Join Date: Dec 2001 Location: NY, NY Posts: 750 Likes: 175 Liked 189 Times in 48 Posts	Chevy EFI - Super Stock Heads & Intake 083 castings (not the later model leakers) Completely updated w/ Brand New valves, etc.. heads were used one season Ran 9.90s in GT/GA in bracket mode w/ bias tires, 20w-50 oil...before the updates! There's a lot left with the updates and a 21st century short-block (honda rods / gun drilled crank...etc) These are as good as new and have been proven to not leak. Can be run as a dish combo at 265hp or as a flat top at 270hp. Prob the best 350 chevy combo out there Also have matching Hughes Sheet Metal Intake Will include EFI programming to the buyer. This set-up would cost $11-$12K (maybe more) I'm asking $7000 for everything, complete ready to bolt on. A short-block is also available (only 80 runs since new) that these heads would bolt right on - Bow-Tie Block / Splayed Caps / Chevy Steel Crank (stroked & lightened but NOT gundrilled) / BME 2-Ring Pistons / Manley Rods / Jesel Belt / Big Pan / Comp Cam / ATI Balancer / etc. Obviously it should be freshened - honed / rings / bearings..... thats it __________________ Angelo DiTocco '98 Firebird SS/HA '98 Firebird B/SA Last edited by Angelo DiTocco; 08-31-2012 at 10:01 AM.