CLASS RACER FORUM - View Single Post

Mike Taylor 3601 · 06-15-2012, 07:11 PM

What Billy said is right, I have ran them at .003. Usaully as example say it was a 350+ .030 skirt measured 4.026 then it was made to be @.004 min.
If pistons have been ran be sure to check skirts were bad to be collasped on those pistons
Mike Taylor 3601

06-15-2012, 07:11 PM	#3
Mike Taylor 3601 VIP Member Join Date: Oct 2008 Location: Somerset,Ky Posts: 1,372 Likes: 358 Liked 308 Times in 103 Posts	Re: TRW piston clearance? What Billy said is right, I have ran them at .003. Usaully as example say it was a 350+ .030 skirt measured 4.026 then it was made to be @.004 min. If pistons have been ran be sure to check skirts were bad to be collasped on those pistons Mike Taylor 3601