CLASS RACER FORUM - View Single Post

Kegracing · 06-10-2011, 10:33 AM

I just installed one of these also, and have been fighting with it... I have the 12 volt running to it, with a normally closed button by tach. I push it, dropping the 12 volts as I stage. Should start recording - correct? The 12 volts do go back to it immediately (momentary break of voltage).

I am not getting recordings, and the shift light does not function correctly when it does not record.

Does the voltage have to drop for any certain amount of time?

What else could I be doing wrong? (loaded question I know... lol)

thanks,

Ken

06-10-2011, 10:33 AM	#3
Kegracing Member Join Date: Jun 2002 Location: Red Oak, TX Posts: 441 Likes: 0 Liked 0 Times in 0 Posts	Re: tach wiring question I just installed one of these also, and have been fighting with it... I have the 12 volt running to it, with a normally closed button by tach. I push it, dropping the 12 volts as I stage. Should start recording - correct? The 12 volts do go back to it immediately (momentary break of voltage). I am not getting recordings, and the shift light does not function correctly when it does not record. Does the voltage have to drop for any certain amount of time? What else could I be doing wrong? (loaded question I know... lol) thanks, Ken