CLASS RACER FORUM - View Single Post

Tom Goldman · 01-06-2011, 07:46 PM

Ed, as long as the area inside of the bolt holes is unmodified ,its good . ..Just make sure to keep the SFI tag on it.
I've used a few of them, and you have to trim them to fit the width of the chassis, so trimming down to the block is ok.
I used one on a BROGIE roadster,and the frame rails on those cars are so narrow, a Dedenbear case wont even fit between them without some grinding!

01-06-2011, 07:46 PM	#11
Tom Goldman VIP Member Join Date: Jan 2003 Location: Allentown,PA Posts: 2,477 Likes: 892 Liked 883 Times in 237 Posts	Re: Gloves and trans shields Ed, as long as the area inside of the bolt holes is unmodified ,its good . ..Just make sure to keep the SFI tag on it. I've used a few of them, and you have to trim them to fit the width of the chassis, so trimming down to the block is ok. I used one on a BROGIE roadster,and the frame rails on those cars are so narrow, a Dedenbear case wont even fit between them without some grinding! __________________ Tom Goldman 1500 SG , 1506 STK Last edited by Tom Goldman; 01-06-2011 at 07:49 PM.