CLASS RACER FORUM - View Single Post

Dave Toce · 03-11-2009, 08:13 PM

I have a 2 channel Autometer playback tach that I use to record every pass I make to make sure the clutch tuning is in line. I just changed a rear gear and when running in the new gear this past weekend I had the magnets come off in the driveway. It appears that the JB weld de-bonded from the U-joint cap. Is there a better or an improved method to attach the two magnets to the driveshaft U-joint caps besides the JB weld that Autometer suggests?
Thanks
Dave

Oopps I just realized I put this in the wrong section sorry..

03-11-2009, 08:13 PM	#1
Dave Toce Junior Member Join Date: Aug 2004 Posts: 34 Likes: 2 Liked 0 Times in 0 Posts	Playback tach magnet question I have a 2 channel Autometer playback tach that I use to record every pass I make to make sure the clutch tuning is in line. I just changed a rear gear and when running in the new gear this past weekend I had the magnets come off in the driveway. It appears that the JB weld de-bonded from the U-joint cap. Is there a better or an improved method to attach the two magnets to the driveshaft U-joint caps besides the JB weld that Autometer suggests? Thanks Dave Oopps I just realized I put this in the wrong section sorry.. Last edited by Dave Toce; 03-11-2009 at 08:15 PM.