View Single Post
Old 03-03-2009, 03:10 PM   #2
west coast
Senior Member
 
Join Date: Dec 2008
Location: Rainy Washington
Posts: 609
Likes: 12
Liked 223 Times in 73 Posts
Default Re: 30" tires on a FOX?

In front of the tire I remove as much as I could about an 1 1/2" at the bottom cut off excess than folded it at 90° back to the inner wheel well and welded. Did this about 9" up tapering to the stock radius of the wheel well at about the trim line. Did alot of cut out of material an hammering in some. Basicly did the same on the back side of the opening also. I think I have some picture of this if not I can take some this weekend. I have not been able to post pictures here but PM me and I can send some.
west coast is offline   Reply With Quote