Looking for 350 sbc forged crank
 

hello if anyone has a 350 forged crank standard journals preferred
would be great for a 72 C 20 project also a 8" balancer thanks roy

Re: Looking for 350 sbc forged crank
 

Roy…Where are you located? MB

Re: Looking for 350 sbc forged crank
 

Long Island ny

Re: Looking for 350 sbc forged crank
 

I have a GM 3.75 stroke crank, rods are 2.1, mains are 2.430,there are new bearings for both, a 6 inch rod was used in this motor, also have a 7 inch ATI balancer and GM flex plate that were part of a balanced assembly. 700.00 for all plus shipping. 2 piece rear seal. Also have a 30 over 4 bolt main block, 400.00 plus shipping.

Re: Looking for 350 sbc forged crank
 

Thanks anyway just need a 350 crank already have the balancer
thanks again

Re: Looking for 350 sbc forged crank
 

Roy… Checkout Albany NY Craigslist. A guy on there has a 350 crank for $100.00, you can faintly make out a wide parting line on 5-6 rod journal. He notes he can't find the casting number (which would be 3932442) if it was cast and it would very legible and poke you in the eye. A Forged Steel Crank commonly would have an 1182 and they can be hard to see. His phone number is in the Reply. Good Luck…Maurice.

Re: Looking for 350 sbc forged crank
 

Thanks will due