Opinions or experience with ISKY E-Z roll lifters
 

Anybody using the Isky E-Z roll lifters? I see Bullet advertising same idea

Re: Opinions or experience with ISKY E-Z roll lifters
 

I use the crower bushed lifters .best thing I ever did. This is in a 10 k rpm eng. No power loss. Went 3 seasons on the lifters. And I am just going to replace them out of guilt. No more fear of broken needles wrecking everything.

Re: Opinions or experience with ISKY E-Z roll lifters
 

Mark,

What kind of spring pressure are you running? Also, any brass in the filter from the lifter bushings?

Thanks,

Steve

Re: Opinions or experience with ISKY E-Z roll lifters
 

345lbs. on the seat new . and change them if they get down to 320 ish. #1356pac. nothing in the filter, and never see any change in the lash either. also running copper inserts in the pushrod cups. they are a radius cup pushrod and ball adjuster

Re: Opinions or experience with ISKY E-Z roll lifters
 

Thanks, Mark.

Re: Opinions or experience with ISKY E-Z roll lifters
 

I have seen alot of sizing issues with those lifters I have had to buy 2 if not 3 sets to make up one set because of sizing issues.

So make sure you measure every lifter.

http://www.yellowbullet.com/forum/sh...t=lifter+bores

Re: Opinions or experience with ISKY E-Z roll lifters
 

you mean the isky's? I haven't had any issues with the crower.

Re: Opinions or experience with ISKY E-Z roll lifters
 

I also have been using the Crower bushed lifters - can't squawk about them at all, but I only rev it to 8,000 :)

Re: Opinions or experience with ISKY E-Z roll lifters
 

This thread I started was about Crower .903 lifters 3 sets that could not be used.

Crower 842. lifters run right at .841 to small for any GM lifter bore that is .844 which gives you .003 clearance which is to much.

Here it a good video to look over.
https://www.youtube.com/watch?v=SpfOKr3B3FA

I deal with a lot of blocks and check and machine alot of lifters and lifters bores when I machine blocks and have seen about every lifter out there.

Re: Opinions or experience with ISKY E-Z roll lifters
 

thanks Carl.