CLASS RACER FORUM

CLASS RACER FORUM (https://classracer.com/classforum/index.php)
-   Stock and Super Stock Tech (https://classracer.com/classforum/forumdisplay.php?f=4)
-   -   Cam Installation (https://classracer.com/classforum/showthread.php?t=51908)

Bobby Lundholm 02-19-2014 09:24 AM
Cam Installation
 
What is the best degree to install a cam on a 396/350 oval port motor for Stock Eliminator? Cam card says 106 but I think that is a little much.

Mike Taylor 3601 02-19-2014 09:52 AM
Re: Cam Installation
 
If cam was ground for that car I would start out @ 106 on 396 106 is probaly about right most BBC cams for N/A usaully are 108-110 but they are 100 + ci over 396
Mike Taylor 3601

Bobby Lundholm 02-19-2014 09:58 AM
Re: Cam Installation
 
Cam was ground for the car.

carl hinkson 02-19-2014 11:55 AM
Re: Cam Installation
 
Is the lobe sep 110?

Bobby Lundholm 02-19-2014 12:00 PM
Re: Cam Installation
 
Lobe separation is 108

Glenn Briglio 02-19-2014 01:10 PM
Re: Cam Installation
 
Start at 106 or whatever you think will work then advance and retard from there to see what car likes. Forget what other people say and try it yourself. Everybody doesn't have the same car and combo.Or put engine on dyno and see what engine likes.


All times are GMT -4. The time now is 08:41 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.