cam company info
 

Does anyone have any thoughts about Bullet cams. I am thinking about buying a cam setup from them but i dont know anyone who runs their stuff. Any personal experiences would help. I posted my setup in 90. heads up tech under cam question. I know comp cams stuff is good but i am interested in bullet as well. Thanks for any help.

Re: cam company info
 

john at Bullet started with Lunati, then Compcams is the guy to talk to.
One of the best Cam guys for ss/stk.

Re: cam company info
 

I use Bullet, if that helps...

Re: cam company info
 

Re: cam company info
 

Bullet;)

Re: cam company info
 

i run a bullet in my amc stocker ,,,and it runs better than expected for the first year out gmonde

Re: cam company info
 

Thanks to all for the info.

Re: cam company info
 

Fastest cam's i've ever used!

Re: cam company info
 

i've used them in many bracket and street motors i have built and owned over the years. when i finish my stocker it will have a BULLET in it too.

Re: cam company info
 

Bullet Cams and John Partridge Rule !

Best Power ever.

Re: cam company info
 

Bullet here too!

Re: cam company info
 

I always used ultradyne cams haven't built an engine in a while checked the ultradyne web site the other day and found it also said bullet cams when did they merg and do you still get them same service and tech support Thanks Harold

Re: cam company info
 

Bullet bought all the Ultra-Dyne masters, designs, parts, engineering, etc. from a Bank when Ultra-Dyne went bankrupt. At least one Ultra-Dyne employee is there, "Tim"

Just consider this, all the Ultra-Dyne designs are at least 6 - 7 or more years old. There have been at least some advancements in cam technology since Harold designed the last Ultra-Dyne cams.

Comp, Cams, Bullet, Cam Motion, Jones Cams will all have up-to-date designs.

And not to say the Ultra-Dyne designs will not run well because they do, however, I think in some situations you will be missing some performance by not running the newest lobes.

Re: cam company info
 

Bullet/ Ultradyne grinds in most everything were building John or Kirk will help steer you if you need input.... no failures yet.

Re: cam company info
 

Guys, be sure to check out their crankshafts, too. I bought one for my new engine. John stroked, indexed, deburred, polished, balanced, drilled and tapped the end (283) and polished the snout (ATI Balancer) etc for $384.00 It looks beautiful and checks dead on. You can pay alot more and receive less. Thanks again, John.

Wade O

Re: cam company info
 

There should be an advertising fee associated with all this fawning .

Re: cam company info
 

Just set the SS/G national record with a Bullet Cam,9.48 at 140.53 2000' air, John is the Man.

Jeff Colvert Racing LLC
CNC Cyl. Heads
4456 SS/G

Re: cam company info
 

Ultra Dyne designs at Bullet, They may have some newer ones

Also all the Ultra Dyne designs and updated designs by the man who designed all the Ultra Dyne lobes are available at Lunati