Re: "Family Tradition" a build for Daughter & Grandchildren
 

We are beginning the frame modification. The new section will be 5 1/2" inboard of the original frame. Once both new sections are properly installed and aligned, the original frame will be cut away. Having the OE frame remaining in place gives a good fixture for accurate alignment.

Re: "Family Tradition" a build for Daughter & Grandchildren
 

We have good progress with the new frame section. When this is finished, the attaching points will be boxed and triangulated. Plus, the shock cross-member and roll bar rear struts will tie it all together

Re: "Family Tradition" a build for Daughter & Grandchildren
 

'Singer... Are the rear tires like a 29.5 x 11.5 or 14 x 32? MB

Re: "Family Tradition" a build for Daughter & Grandchildren
 

Maurice, 29.5 x 11. The wheels and tires pictured are for mockup, and I will likely run a radial in the 29.5 x 11 range. The bias tires pictured are new but several years old. I might run the bias for a few test outings.

Re: "Family Tradition" a build for Daughter & Grandchildren
 

A few updated photos.

Re: "Family Tradition" a build for Daughter & Grandchildren
 

When the frame mods are complete, all will be braced and triangulated as needed. Another cross-member will accommodate the shocks, and the Antiroll bar will be in front of the diff.

Re: "Family Tradition" a build for Daughter & Grandchildren
 

Old reliable, simple, easy, ladder bar.

Re: "Family Tradition" a build for Daughter & Grandchildren
 

Job change note: I originally planned on utilizing CalTracs, but after a time of pondering, I changed by mind [I do that ofter] and decided to make room for a wider tire and install the ladder bar set.

Re: "Family Tradition" a build for Daughter & Grandchildren
 

The ladder bars and shocks are as far outboard as the new frame will allow. The pinion is centered.

Re: "Family Tradition" a build for Daughter & Grandchildren
 

A fellow could buy a kit to do such a modification, but I like the challenge and the thought process of a custom design. I will have the overall idea in mind, but the steps between the beginning and the end are a process of one step at a time with some deviation along the path.