CLASS RACER FORUM
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

CLASS RACER FORUM (https://classracer.com/classforum/index.php)
-   Stock and Super Stock (https://classracer.com/classforum/forumdisplay.php?f=3)
-   -   plastic printing (https://classracer.com/classforum/showthread.php?t=71008)

David Lee 09-17-2018 06:39 PM
Re: plastic printing
 
Quote:
Originally Posted by Myron Piatek (Post 573031)
I'll ask/check around. Don't know if it's accurate, but I've heard it referred to as "phenolic".

There is a source for small primary bowls for under $150, which I don't know if they are still being manufactured or there is just a large overstock. But no source for big primary bowls that I'm aware of.
i just joined a 3d printing forum and asked if there is any plastic that can stand being in contact with gasoline. i am going to take apasrt a junk tq i have and see what it looks like and what screw holes that would have to created. do you think having brass inserts for the screws to be needed?

Myron Piatek 09-17-2018 09:20 PM
Re: plastic printing
 
Quote:
Originally Posted by David Lee (Post 573032)
i just joined a 3d printing forum and asked if there is any plastic that can stand being in contact with gasoline. i am going to take apasrt a junk tq i have and see what it looks like and what screw holes that would have to created. do you think having brass inserts for the screws to be needed?
From what I've seen, the only brass inserts are for the primary jets. Then there are those 2 "caps" that are epoxied under the main jets. All of the cover screws thread into the aluminum base. The fuel bowl center section simply provides "pass through" holes.

I'm still learning and coincidentally, took apart my first 2 good TQ's, changed the jetting and reassembled them this past weekend.:D Still gotta try them out.

Chad Fergen 09-18-2018 12:41 AM
Re: plastic printing
 
Quote:
Originally Posted by David Lee (Post 573025)
can you tell me what printers you are using?


Thanks
All are Stratasys. The largest we can do is a 18 inch part.

Chad Fergen 09-18-2018 12:43 AM
Re: plastic printing
 
Quote:
Originally Posted by David Lee (Post 573025)
can you tell me what printers you are using?


Thanks
If you are looking for an inexpensive printer to get started, let me know. "i got a guy" :) txt605-690-1240


All times are GMT -4. The time now is 04:52 AM.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.