In the final stages of development, a test session of 6 racers on the practice tree with the Just-N-Time Button let go over 600 times showing results of adjustability of .085 - .100 from standard trans-brake buttons and approximately .040 slower than other current slow buttons on the market. In the final stages of development, a test session of 6 racers on the practice tree with the Just-N-Time Button "let go" over 600 times showing results of adjustability of .085 - .100 from standard trans-brake buttons and approximately .040 slower than the current slow buttons on the market. The Just-N-Time Button offers maximum adjustability by allowing racers the ability to select one of 6 spring ratios and a combination of spacer configurations. All of which can be done right in the race car without any tools needed. The button body and the activating shaft of the Just-N-Time Button is produced from an extremely high quality plastic which is temperature stable from -20 to 180 degrees Fahrenheit, eliminating any possible clearance and activation variables. Each Just-N-Time Button comes with the 6 springs, multiple spacers and a spare spring retention bolt and stand, all of which can be stored right in your race car in the provided case for quick adjustability right in the staging lanes. The Just-N-Time Button is Made in American and the small-ware parts are stainless steel, showcasing the quality put into this product. The Just-N-Time Button is a product of Collector Tethers and is now available for purchase. Visit www.JNTButton.com to purchase your button today. |