|
03-03-2018, 11:15 AM | #1 |
Member
Join Date: Dec 2002
Location: malden,ma
Posts: 236
Likes: 239
Liked 82 Times in 37 Posts
|
super stock 305 intakes
sorry, don't know now to cancel. . jeff
Last edited by stock1080; 03-04-2018 at 11:58 AM. Reason: this was a dum ? on my part |
03-04-2018, 12:34 AM | #2 |
Senior Member
Join Date: Feb 2009
Posts: 934
Likes: 358
Liked 167 Times in 77 Posts
|
Re: super stock 305 intakes
touchy subject...
|
03-07-2018, 12:29 AM | #3 |
Member
Join Date: Jan 2016
Location: Colorado hills
Posts: 123
Likes: 11
Liked 73 Times in 36 Posts
|
Re: super stock 305 intakes
Sir 305,
You might find that a GM OEM valve that is 2.00" diameter and has a hollow stem would work well when reduced in diameter and reshaped. The shape is best decided on a flow bench, but at least that is a good start. Since any valve job is legit, you might also find that something less than the original 45 degree face/seat is also more beneficial because of the relatively low lifts of those engines. However, like many things there are various opinions that can be either refuted or supported via your own test data. Regards, HB2 Dissident Above comments are for Stock, not SS. However the selection of the valve might be the same answer and the face/seat be steeper than 45 degrees. Intake valve shape should end up with a 10-12max degree backside. Last edited by Dissident; 03-07-2018 at 12:34 AM. Reason: addressed stock and not SS |
03-07-2018, 08:51 AM | #4 |
Member
Join Date: Dec 2002
Location: malden,ma
Posts: 236
Likes: 239
Liked 82 Times in 37 Posts
|
Re: super stock 305 intake
I deleted the ? It was about intake manifolds. A lot of viewers of ? I understand now why I couldn't get the simplest answer. I respect that. tks jeff
|
|
|