|
09-27-2018, 01:40 PM
|
#1 |
|
Member
Join Date: Sep 2006
Location: Moncton, N.B.
Posts: 276
Likes: 24
Liked 24 Times in 13 Posts
|
Auto Meter 6896
Has anyone had any experience with the
Auto Meter Ultimate play back tach model # 6896.I am looking for a simple, but effective, way to monitor my engine RPM vs drive shaft RPM. Terry K |
|
|
|
09-27-2018, 02:01 PM
|
#2 |
|
Senior Member
Join Date: Feb 2002
Location: Southeast Michigan
Posts: 885
Likes: 63
Liked 221 Times in 102 Posts
|
Re: Auto Meter 6896
What I do is make a run , then make a change , and compare the two runs by overlaying the traces . Typically if you can make areas of the driveshaft rpm get faster at a particular time stamp (acceleration) , then you have found an improvement .
|
|
|
|
|
09-27-2018, 02:21 PM
|
#3 |
|
Member
Join Date: Nov 2001
Location: Saint John, NB Canada
Posts: 117
Likes: 299
Liked 68 Times in 22 Posts
|
Re: Auto Meter 6896
Good Unit for the Money. Also allows for a PSI sensor.
|
|
|
|
|
09-27-2018, 02:30 PM
|
#4 |
|
Member
Join Date: Sep 2006
Location: Moncton, N.B.
Posts: 276
Likes: 24
Liked 24 Times in 13 Posts
|
Re: Auto Meter 6896
Thanks Mark for the reply.
"ss3011", are you using a 6896 unit? TK |
|
|
|
|
09-27-2018, 03:45 PM
|
#5 |
|
Senior Member
Join Date: Feb 2002
Location: Southeast Michigan
Posts: 885
Likes: 63
Liked 221 Times in 102 Posts
|
Re: Auto Meter 6896
Ultimate II , I believe it uses similar software , but the 6896 allows data log of O2 sensors , pressures , etc. Comparing driveshaft rpm should be a valid way of determining improvements .
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -4. The time now is 10:09 AM.