|
01-26-2019, 05:00 PM | #11 |
Member
Join Date: Mar 2010
Posts: 299
Likes: 35
Liked 32 Times in 28 Posts
|
Re: Renegade RM K-16 Drag Elite vs VP Q-16
HSMITH1039,
How much difference in the jetting from one fuel to the other, if any? Thanks..... Last edited by Shake & Bake; 01-26-2019 at 05:03 PM. |
01-27-2019, 11:09 AM | #12 |
Junior Member
Join Date: Nov 2016
Posts: 22
Likes: 0
Liked 6 Times in 5 Posts
|
Re: Renegade RM K-16 Drag Elite vs VP Q-16
None......we didn't change anything. Both worked well, just a lot easier for me to get VP.
|
01-27-2019, 06:42 PM | #13 |
Member
Join Date: Mar 2010
Posts: 299
Likes: 35
Liked 32 Times in 28 Posts
|
Re: Renegade RM K-16 Drag Elite vs VP Q-16
If that's the case I just might switch. My fuel guy had a fallen out with the folks at VP and doesn't get the Q16 anymore. So now it would be easier for me to go the Renegade route.
Thanks! Appreciate the input.......... |
02-02-2019, 11:00 AM | #14 |
Member
Join Date: Feb 2002
Posts: 328
Likes: 64
Liked 345 Times in 149 Posts
|
Re: Renegade RM K-16 Drag Elite vs VP Q-16
Is your carb specifically built for Q16?
To maximize gains from Q16, the carb needs to be calibrated for the Q and the higher fuel requirements. I have a Book/BRE 1250 that has been awesome. Best carb I've owned so far over Cubic, APD... |
02-06-2019, 05:03 PM | #15 |
Member
Join Date: Mar 2010
Posts: 299
Likes: 35
Liked 32 Times in 28 Posts
|
Re: Renegade RM K-16 Drag Elite vs VP Q-16
Todd,
Yes my carbs are calibrated for the Q16 fuel. Spoke with the Quick Fuel folks the other day and went back over the calibration sheet with them. They recommended going a little richer with the intermediate bleed and the high speed. Mostly the high speed bleed being I'm out of the intermediate range at WOT. I also asked them about running the Renegade RM K-16 Drag Elite fuel compared to running the VP Q16 in the carbs. They told me they are very similar and I should be good to go. Thanks...... |
|
|