Solid roller lifters for LT1 - Page 2

e vassar · 04-11-2019, 01:08 PM

Which one?

ss3011 · 04-11-2019, 01:34 PM

The one on the right is a solid roller lifter , I think to run a tie bar style lifter in a late model LT1 block you need to have the .300" tall solid roller lifters .

Rich Biebel · 04-11-2019, 02:02 PM

On my LT-1 Stocker, I used Bullet short travel hydraulic rollers with the tie bars and recall those lifters could not be installed or removed with the head on...….

They were to tall and hit the head before they cleared the lifter bores

I Never had a reason to remove them so it was not a problem.....

Ed Wright · 04-11-2019, 05:28 PM

Quote:

Originally Posted by Rich Biebel

On my LT-1 Stocker, I used Bullet short travel hydraulic rollers with the tie bars and recall those lifters could not be installed or removed with the head on...….

They were to tall and hit the head before they cleared the lifter bores

I Never had a reason to remove them so it was not a problem.....

That sounds like my Isky Red Zones. Like the shorter pushrods they need.
I am amazed solid lifters are now allowed in Stockers that didn't come with them.
Been too long since I ran Stock. I find how fast they are now very impressive.

04-11-2019, 01:08 PM	#11
e vassar Member Join Date: Jul 2015 Posts: 354 Likes: 61 Liked 238 Times in 93 Posts	Re: Solid roller lifters for LT1 Which one? Attached Thumbnails

04-11-2019, 01:34 PM	#12
ss3011 Senior Member Join Date: Feb 2002 Location: Southeast Michigan Posts: 885 Likes: 63 Liked 221 Times in 102 Posts	Re: Solid roller lifters for LT1 The one on the right is a solid roller lifter , I think to run a tie bar style lifter in a late model LT1 block you need to have the .300" tall solid roller lifters .

04-11-2019, 02:02 PM	#13
Rich Biebel VIP Member Join Date: Jun 2007 Location: Northern New Jersey suburbs Posts: 2,275 Likes: 25 Liked 510 Times in 200 Posts	Re: Solid roller lifters for LT1 On my LT-1 Stocker, I used Bullet short travel hydraulic rollers with the tie bars and recall those lifters could not be installed or removed with the head on...…. They were to tall and hit the head before they cleared the lifter bores I Never had a reason to remove them so it was not a problem..... __________________ Rich Biebel S/C 1479

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode