Trans shield Clarificaion - Page 2

Rich Biebel · 02-22-2012, 07:57 PM

If you race your 10 second Stocker at a local track in brackets or test and tune the rule book says a trans shield is required. Before Stockers needed SFI Jackets that was also required.

Depending on where you go to race.....you might get asked if you have one. Or Not....LOL

Michael Beard · 02-27-2012, 11:20 AM

Safety rules should be predicated on a car's E.T., MPH, and chassis type/construction only. Why would safety requirements change based on the decals on the window?

StockerRook · 02-27-2012, 02:48 PM

Thanks for the clarification everybody. I went ahead and purchased one but getting this thing to fit with the trans tunnel, torque arm, tranny cooler line fittings, etc. Is proving quite difficult. Def would like to run one if I can make it work. Thx for all the input

02-22-2012, 07:57 PM	#11
Rich Biebel VIP Member Join Date: Jun 2007 Location: Northern New Jersey suburbs Posts: 2,275 Likes: 25 Liked 510 Times in 200 Posts	Re: Trans shield Clarificaion If you race your 10 second Stocker at a local track in brackets or test and tune the rule book says a trans shield is required. Before Stockers needed SFI Jackets that was also required. Depending on where you go to race.....you might get asked if you have one. Or Not....LOL __________________ Rich Biebel S/C 1479 Last edited by Rich Biebel; 02-22-2012 at 08:01 PM.

02-27-2012, 11:20 AM	#12
Michael Beard VIP Member Join Date: Sep 2002 Location: Columbus, OH Posts: 4,060 Likes: 0 Liked 12 Times in 8 Posts	Re: Trans shield Clarificaion Safety rules should be predicated on a car's E.T., MPH, and chassis type/construction only. Why would safety requirements change based on the decals on the window? __________________ Michael Beard - NHRA/IHRA 3216 S/SS

02-27-2012, 02:48 PM	#13
StockerRook Junior Member Join Date: Jan 2009 Posts: 36 Likes: 0 Liked 0 Times in 0 Posts	Re: Trans shield Clarificaion Thanks for the clarification everybody. I went ahead and purchased one but getting this thing to fit with the trans tunnel, torque arm, tranny cooler line fittings, etc. Is proving quite difficult. Def would like to run one if I can make it work. Thx for all the input