|
05-18-2020, 07:54 PM | #1 |
Member
Join Date: Feb 2002
Location: Marion, Ohio
Posts: 179
Likes: 3
Liked 33 Times in 13 Posts
|
Flowmaster collector
On a set of Flowmaster Scavenger 4 2 1 collectors where is the best place to install the crankcase evac fitting ? Should you install it in the side behind the 4 small tubes or behind the 2 tubes ? I'm afraid if it's installed too far back it may not pull enough vacuum.
|
05-19-2020, 11:03 AM | #2 |
Member
Join Date: May 2011
Location: Auburndale,Florida
Posts: 207
Likes: 21
Liked 59 Times in 33 Posts
|
Re: Flowmaster collector
It was a long time ago , but I tried a set on my 302 bracket motor. I believe I had the bung for the evac placed after the small tubes in the final exit pipe. I never played with them on a dyno, but I don’t remember seeing anything at the track. My advice would be get a set of merge collectors.The 421 deal might pick up a little, but I think it would be more of a fine tuning adjustment.
|
Liked |
|
|