|
|
04-16-2008, 11:07 PM | #1 |
Junior Member
Join Date: Mar 2008
Posts: 73
Likes: 0
Liked 0 Times in 0 Posts
|
Billet Aluminum Dash Bezel
Got the gauges picked out I think for the dash project. . I downloaded the ones I want off the net, sized em' to the specs on the site & printed the faces out on the printer. Then I cut some PVC gauge housings on the CNC. They are a little deeper than the actual gauges but that'll insure I have ample room for the real deals down the road. Now I can make a bezel. That outta' keep me busy for awhile.
Cut the bezel out on the CNC. There's a bunch of steps to get this thing cut. I keep thinkin' one BooBoo & it's scrap. :shock: Got the bezel off the table. Now comes the task of bending it in the right places & at the correct angles to fit the dash. Got it roughed into the dash cover. Still rough but close enough that I know it will fit. The right wing is 1/2" longer than the left wing, so angles are different. I think I got it purdy' close though. Next is to cut the contour in the fiberglass for the oversized tach & speedo. {that's a relief} |
04-19-2008, 11:05 PM | #2 |
Junior Member
Join Date: Mar 2008
Posts: 73
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Billet Aluminum Dash Bezel
Got a little further on the dash today. I made plugs out of PVC to form the gauge wells, since these gauges are too big for the original bezel opening.
I did the kitty hair "form the bezel to the dash deal" again. Used vinyl & spray Pam as a release agent. One last big hurtle for me. TIG welding on the bezel w/o ruining it. I welded some strap aluminum to the top & bottom to stiffen up the bezel & to provide a place for rubber mounting grommets. Got the bezel just setting in place. It's being held in by the dash bar. Close enough to see what it'll look like. |
04-21-2008, 11:39 AM | #3 |
Junior Member
Join Date: Oct 2004
Location: east brunswick, new jersey
Posts: 62
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Billet Aluminum Dash Bezel
very nice work...
go into business for yourself and sale one to me. i got a 79 camaro it would look great. the cost of gauges would be preety high to. but, hell if you had to ask how much you should not be here.
__________________
S/ST 1739 Carlos Mendes |
04-21-2008, 12:08 PM | #4 |
Junior Member
Join Date: Mar 2008
Posts: 73
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Billet Aluminum Dash Bezel
If I told you how many hours I had in that thing you would laugh.....
|
04-21-2008, 05:12 PM | #5 |
VIP Member
Join Date: Feb 2006
Location: Dela-where?
Posts: 2,116
Likes: 1,004
Liked 1,649 Times in 521 Posts
|
Re: Billet Aluminum Dash Bezel
man, that does look good, nice to see someone take pride in their work.
|
04-23-2008, 10:44 PM | #6 |
Junior Member
Join Date: Mar 2008
Posts: 73
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Billet Aluminum Dash Bezel
Thanks Keith
|
|
|