|
![]() |
#1 |
Member
Join Date: Nov 2001
Location: Marion,In.
Posts: 257
Likes: 43
Liked 92 Times in 23 Posts
|
![]()
What is the preferred distance between the flexplate and convertor pads when the convertor is all the way engaged in the pump? I know it's less than the other turbo's and am thinking A-1 told me a few years back around .100. Just want to make sure. Thanks for your response.
|
![]() |
![]() |
![]() |
#2 | |
Member
Join Date: Oct 2005
Location: N.S. CANADA
Posts: 498
Likes: 155
Liked 68 Times in 41 Posts
|
![]() Quote:
all depends on the over all height of the converter.1/8 to 1/4 at the most.As long as the hub is still all the way in the pump gear all should be good.
__________________
1231 FS/D Drag Pak 1231 E/SA 71 Demon Kelly MacKay |
|
![]() |
![]() |
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Raleigh NC
Posts: 628
Likes: 27
Liked 243 Times in 73 Posts
|
![]()
Basically you want the converter about an 1/8 inch from bottoming out on the pump lugs.With the converter bottomed out on the pump, measure the lug to flexplate distance, subtract 1/8 inch (.125) and that is the spacer(s) needed. That is how I installed mine and no issues.
__________________
Mike Moller NHRA 203 Q-R-T/SA |
![]() |
![]() |
![]() |
|
|