|
12-17-2012, 05:27 PM | #21 |
Senior Member
Join Date: May 2004
Posts: 801
Likes: 1
Liked 10 Times in 6 Posts
|
Re: stocker cylinder heads
Wrong information
__________________
Tom Moock 5704 STK Last edited by Tom Moock; 12-17-2012 at 06:37 PM. Reason: Post wrong information |
12-17-2012, 10:40 PM | #22 |
Member
Join Date: May 2009
Posts: 170
Likes: 35
Liked 43 Times in 24 Posts
|
Re: stocker cylinder heads
Thanks to all who responded. Ron.
|
12-17-2012, 11:11 PM | #23 |
Junior Member
Join Date: Jul 2010
Posts: 20
Likes: 0
Liked 0 Times in 0 Posts
|
Re: stocker cylinder heads
Wade you are 100% correct , been there done that !
|
12-18-2012, 10:00 AM | #24 |
VIP Member
Join Date: Oct 2008
Location: Somerset,Ky
Posts: 1,303
Likes: 198
Liked 116 Times in 48 Posts
|
Re: stocker cylinder heads
Alan,
You are talking about newen cnc guide& seat machine,that makes all cuts with one insert correct, that or cutting radius on bottom of seat before installing is only way I know to have seat radiused on lower side of seat to bowl area. When you say radius seat you are talking about seat that is radiused below where valve seats so that it creates a venturi,just making sure we are talking about same thing. Do you know anyone with Newen cnc guide&seat machine ,watched those videos lots of times,just curious how they are in the real world? Have'nt went to any trade shows for 8 years went every year from Nashville PRI till last at Indy kinda was burnt out on them,may go to Indy PRI next year. Mike Taylor 3601 |
Thread Tools | |
Display Modes | |
|
|