|
02-06-2018, 09:59 PM | #1 |
Member
Join Date: Feb 2003
Location: Lakeville, Ma
Posts: 253
Likes: 0
Liked 0 Times in 0 Posts
|
WTB Input Shaft for Jerico DR4
Looking to buy a Course spline (18 Mopar) Input Shaft for a DR4 Small Bearing Jerico
Thanks in advance!....Don
__________________
Don Fardie 1582 F/S B/G |
02-07-2018, 10:26 AM | #2 |
VIP Member
Join Date: Dec 2001
Location: Arkansas - In the middle of everything.
Posts: 1,980
Likes: 52
Liked 724 Times in 177 Posts
|
Re: WTB Input Shaft for Jerico DR4
Length?
__________________
|
02-07-2018, 12:17 PM | #3 |
Member
Join Date: Feb 2003
Location: Lakeville, Ma
Posts: 253
Likes: 0
Liked 0 Times in 0 Posts
|
Re: WTB Input Shaft for Jerico DR4
Wasn't aware there were different lengths? I know there is a shorter version of the Jerico, but not the inputs. If that is the case it would be the input for the standard length Jerico.
__________________
Don Fardie 1582 F/S B/G |
02-13-2018, 05:59 PM | #4 |
Member
Join Date: Jan 2012
Location: In between cecil & the grove
Posts: 170
Likes: 1,109
Liked 186 Times in 57 Posts
|
Re: WTB Input Shaft for Jerico DR4
|
02-14-2018, 06:16 AM | #5 | |
VIP Member
Join Date: Dec 2004
Location: Cumming GA
Posts: 1,928
Likes: 1,064
Liked 1,212 Times in 249 Posts
|
Re: WTB Input Shaft for Jerico DR4
Quote:
The thing to watch is the type and version of the input. The early narrow gear DR4 is different than the small bearing wide gear DR4 vs the Big bearing wide gear DR4 vs the DR4-4. Not to mention other versions that are not DR. Models. Of course, the pilot tip can be different as well. The length of the trans won’t matter unless you are talking output shafts. You might check to see what the case number is on your trans and call Scott at Jerico. They are not too expensive compared to used and you will get a new one. If you have an older model and can’t get one new, you need to do some research to be sure it is compatible. Hope this helps. Jim
__________________
James Schaechter 3163 STK |
|
02-14-2018, 03:09 PM | #6 |
Member
Join Date: Feb 2003
Location: Lakeville, Ma
Posts: 253
Likes: 0
Liked 0 Times in 0 Posts
|
Re: WTB Input Shaft for Jerico DR4
Actually all set guys. I bought a back up Jerico and it is the early Narrow Gear and it came with a fine 26 spline. I switched over to the 18 Mopar set up when I went to the dual clutch. Dean Cook had one but had lent it out to someone and it was never returned. Well in looking on E-Bay the one I saw looked real close to one I had that I was using as an alignment tool. Bottom Line ...guess who had Deans Input shatft!!!!. My memory is good....it just a tad short LOL!!!
Thanks for all your help and input .......Don
__________________
Don Fardie 1582 F/S B/G |
|
|