|
01-14-2018, 03:54 PM | #1 |
Member
Join Date: Jan 2005
Location: North Massapequa, NY
Posts: 218
Likes: 0
Liked 0 Times in 0 Posts
|
driveshaft speed sensor
Can someone let me know the pin out configuration for the autometer drive shaft speed sensor? I want to use it with my mega squirt ecm. What color is ground, power and signal? I cold not find it on their website. Thanks.
|
01-14-2018, 04:10 PM | #2 |
VIP Member
Join Date: Jun 2006
Posts: 3,349
Likes: 328
Liked 280 Times in 150 Posts
|
Re: driveshaft speed sensor
Black is ground white is signal red is power that's the way we always run it Fed
|
01-14-2018, 06:21 PM | #3 |
Member
Join Date: Jan 2005
Location: North Massapequa, NY
Posts: 218
Likes: 0
Liked 0 Times in 0 Posts
|
Re: driveshaft speed sensor
Thanks Fed!! Im going to reuse my cable also that went to my tach. The end of the jumper cable at the sensor has a three wire connector but the other end that goes by the tach has a 4 wire connector. Is the fourth pin a shield?
Last edited by L79racer; 01-14-2018 at 06:24 PM. |
01-22-2018, 08:39 PM | #4 |
Member
Join Date: Jan 2005
Location: North Massapequa, NY
Posts: 218
Likes: 0
Liked 0 Times in 0 Posts
|
Re: driveshaft speed sensor
|
01-23-2018, 10:33 AM | #5 |
Member
Join Date: Jan 2005
Location: North Massapequa, NY
Posts: 218
Likes: 0
Liked 0 Times in 0 Posts
|
Re: driveshaft speed sensor
Ok, have the info I need. Ill post it here in case someone else will need it one day.
Connector has terminals marked A,B,C A -Blue is ground B- black is signal C- tan is 12 volts |
|
|