Sunnen CV 616

R Hastings · 02-04-2015, 03:46 PM

Had to hone a block this morning. Regular operator home sick. It seemed that no mater what settings were used the auto feed wouldn't keep consistent pressure. pressure would back off unless I kept slight pressure on feed wheel with my hand. Rough hone using diamond stones. Any thoughts on what may be wrong.

carl hinkson · 02-05-2015, 09:44 AM

Quote:

Originally Posted by R Hastings

Had to hone a block this morning. Regular operator home sick. It seemed that no mater what settings were used the auto feed wouldn't keep consistent pressure. pressure would back off unless I kept slight pressure on feed wheel with my hand. Rough hone using diamond stones. Any thoughts on what may be wrong.

If your using diamond stones you may have to adjust pressure feed wheel to a higher number.

Mike Taylor 3601 · 02-05-2015, 10:06 AM

I would say needed more pressure also.
Mike Taylor 3601

R Hastings · 02-05-2015, 09:07 PM

Thanks for the replies. We tried adjusting the pressure wheel up to the max with no improvement. We also tried regular roughing stones with the same results. We are going to try the tech line for suggestions.

Randy Hastings

rickseeman · 02-06-2015, 10:29 AM

Increase the feed under the head.

02-04-2015, 03:46 PM	#1
R Hastings Junior Member Join Date: Sep 2005 Location: Medicine Hat Posts: 28 Likes: 0 Liked 0 Times in 0 Posts	Sunnen CV 616 Had to hone a block this morning. Regular operator home sick. It seemed that no mater what settings were used the auto feed wouldn't keep consistent pressure. pressure would back off unless I kept slight pressure on feed wheel with my hand. Rough hone using diamond stones. Any thoughts on what may be wrong.

02-05-2015, 10:06 AM	#3
Mike Taylor 3601 VIP Member Join Date: Oct 2008 Location: Somerset,Ky Posts: 1,303 Likes: 198 Liked 116 Times in 48 Posts	Re: Sunnen CV 616 I would say needed more pressure also. Mike Taylor 3601

02-05-2015, 09:07 PM	#4
R Hastings Junior Member Join Date: Sep 2005 Location: Medicine Hat Posts: 28 Likes: 0 Liked 0 Times in 0 Posts	Re: Sunnen CV 616 Thanks for the replies. We tried adjusting the pressure wheel up to the max with no improvement. We also tried regular roughing stones with the same results. We are going to try the tech line for suggestions. Randy Hastings

02-06-2015, 10:29 AM	#5
rickseeman Member Join Date: Sep 2011 Location: Stuttgart, AR Posts: 121 Likes: 0 Liked 1 Time in 1 Post	Re: Sunnen CV 616 Increase the feed under the head.