|
![]() |
#1 |
Junior Member
Join Date: Dec 2003
Location: ALTA LOMA , CA
Posts: 92
Likes: 0
Liked 1 Time in 1 Post
|
![]()
I have looked on thier website and those that sell thier products ... doesnt seem like they are making the stock /superstock legal q jets anymore ? i belive the part # were 1902 -1904 ?? any info appreciated
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
![]()
You can still find them on e-bay,or you can call Dean Oliver.
Thanks, Alan Warman L/SA 4103 |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
![]()
they did stop making the s/ss carbs a couple years ago .do not no why they disscontinued them.
|
![]() |
![]() |
#4 |
Junior Member
Join Date: Dec 2003
Location: ALTA LOMA , CA
Posts: 92
Likes: 0
Liked 1 Time in 1 Post
|
![]()
well thats just great ... thanks
|
![]() |
![]() |
![]() |
#5 |
Junior Member
Join Date: May 2002
Location: Stuttgart, AR
Posts: 53
Likes: 1
Liked 0 Times in 0 Posts
|
![]()
davy,
Alan and Larry are correct, Edelbrock discontinued the Q-jet carburetor line almost two years ago. Anything you find now is new old stock. Edelbrock does, however, still carry tuning parts (jets, rods, hangers, etc.). Edelbrock actually used the same company (Magnetti Merelli) that Rochester used to produce the carbs for them, so there is no advantage/disadvantage one way or the other. The 1901 and 1902 carbs were the small Q-jet (1.093" primary venturi) and the 1903, 1904, and 1910 were the large Q-jet (1.218" primary venturi). You can still find these on ebay like Alan mentioned, or I do still have a stock of new ones in inventory. It's too bad that no one has stepped up to re-start production of these carbs. I keep my fingers crossed, but as time goes by, I believe the likelihood of that happening gets less and less. Hope this helps. Dean |
![]() |
![]() |
![]() |
#6 |
Member
Join Date: Nov 2001
Location: Marion,In.
Posts: 259
Likes: 44
Liked 108 Times in 25 Posts
|
![]()
You can get the remanufactured Edelbrock Q-Jets #1902 ( #9972 ) and #1903 ( #9973 ) from Jeg's and Summit with Jeg's being a little less expensive. I have blueprinted some of these and other than not having the Edelbrock tags, they look new. The ones I did didn't even appear to have been bolted on. I wouldn't be afraid to recommend them to a customer. Danny @ Q-Jet Performance.
|
![]() |
![]() |
![]() |
|
|