|
03-04-2015, 07:27 PM | #1 |
Senior Member
Join Date: Aug 2006
Location: Pukwana SD
Posts: 858
Likes: 555
Liked 97 Times in 47 Posts
|
Headers
Anyone out there have a header builder that sells flanges?Small block 23* hooker spead bolt pattern
|
03-04-2015, 08:27 PM | #2 |
Member
Join Date: Dec 2012
Posts: 227
Likes: 4
Liked 161 Times in 45 Posts
|
Re: Headers
I recently needed an oddball set. I called Neil and Parks. Great service, parts are right, and timely delivery.
|
03-04-2015, 08:33 PM | #3 |
VIP Member
Join Date: Feb 2003
Location: Glendale, Arizona
Posts: 2,991
Likes: 693
Liked 1,457 Times in 543 Posts
|
Re: Headers
SPD exhaust has the largest selection of exhaust flanges for every car and cylinder head make.
http://www.spdexhaust.com/Header-FlangesB.html |
03-05-2015, 11:35 AM | #4 |
Veteran Member
Join Date: Mar 2005
Location: Sand Springs, OK
Posts: 8,132
Likes: 896
Liked 389 Times in 168 Posts
|
Re: Headers
Jim, I got Jere Stahl to cut a custom set of flanges for a set of Hedman Hustlers that used his bolt pattern. He had me take a file folder, open it up and lay it on the head, and use a gasket hammer to cut it out like making a gasket. Just folded the folder back up, and mailed it to them. With my Heads Up! raised exhaust ports, Hedman's factory flanges didn't put the tube over the port correctly. He had me do the same with my new head, for the new headers they built for me. I feel fortunate to have gotten a set from them shortly before they shut down.
You can probably get SPD, or one of those other header flange makers to do the same for you.
__________________
Ed Wright 4156 SS/JA |
03-05-2015, 11:55 AM | #5 |
Senior Member
Join Date: Aug 2006
Location: Pukwana SD
Posts: 858
Likes: 555
Liked 97 Times in 47 Posts
|
Re: Headers
Thanks I tried spd they sent one that's not even close, Will try Neil&Parks .
|
03-05-2015, 03:07 PM | #6 |
Junior Member
Join Date: Feb 2013
Location: cleveland ,ohio
Posts: 40
Likes: 1
Liked 0 Times in 0 Posts
|
Re: Headers
http://www.stainlessheaders.com/flanges
Or, http://bendtubing.com/index.php Im not sure if he makes flanges. But itll be worth the call. He's very reasonable.
__________________
Steve Tucholsky |
03-05-2015, 05:48 PM | #7 | |
Junior Member
Join Date: Jan 2010
Location: Orlando, Fl.
Posts: 39
Likes: 6
Liked 0 Times in 0 Posts
|
Re: Headers
Quote:
Jim. I can AutoCAD and have them Laser Cut out of stainless or Mild Steel P&O. Do you have a Header Gasket? If so message me and I will give you my address and I will quote this for you
__________________
________________________ Tim Takash Super Stock 248 |
|
|
|