|
![]() |
#1 |
Member
Join Date: May 2014
Location: E TN
Posts: 448
Likes: 14
Liked 109 Times in 63 Posts
|
![]()
Other discussion about MC's and the mention of a MC with 60/40 bias.
Someone explain to me how the MC can have 60/40 bias when the bore in the MC is the same size for both pistons/ports. I know GM used some step bore MC's where the pistons are different sizes for each port which makes sense using hydraulic principles where the same pressure is applied to 2 different size pistons results in different pressure out of the ports. |
![]() |
![]() |
![]() |
#2 |
Member
Join Date: Aug 2010
Location: CT
Posts: 412
Likes: 1,331
Liked 291 Times in 124 Posts
|
![]()
The positioning of the "cups" are staggered, which changes the timing of the application of pressure
__________________
Phil Molski PMR Performance S/C 1623 |
![]() |
![]() |
Liked |
![]() |
#3 |
Member
Join Date: May 2014
Location: E TN
Posts: 448
Likes: 14
Liked 109 Times in 63 Posts
|
![]() |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Aug 2010
Location: CT
Posts: 412
Likes: 1,331
Liked 291 Times in 124 Posts
|
![]()
They will be different, due to the compression on one side versus the other - start compressing later would result in lower pressure.
__________________
Phil Molski PMR Performance S/C 1623 |
![]() |
![]() |
![]() |
#5 |
VIP Member
Join Date: Nov 2007
Location: New Jersey
Posts: 1,835
Likes: 79
Liked 468 Times in 218 Posts
|
![]()
Pressure can only be increased by changing the pedal ratio or by decreasing the master cylinder bore.
|
![]() |
![]() |
![]() |
#6 |
Junior Member
Join Date: Feb 2013
Location: Pasco, Wa.
Posts: 15
Likes: 0
Liked 3 Times in 2 Posts
|
![]()
The bias is likely volume not pressure.
|
![]() |
![]() |
![]() |
#7 |
Member
Join Date: May 2014
Location: E TN
Posts: 448
Likes: 14
Liked 109 Times in 63 Posts
|
![]()
How does it put more volume to one port? Same bore size operated by the same pedal stroke.
|
![]() |
![]() |
![]() |
#8 |
Junior Member
Join Date: Dec 2009
Location: Winnipeg, MB
Posts: 89
Likes: 206
Liked 19 Times in 11 Posts
|
![]()
The piston is elongated with a chamber in the middle section. The forward chamber is pressurized by the front of the piston, full bore diameter.
The middle chamber is also pressurized but has reduced area due to the middle diameter of the piston carrying across to the forward piston. At any given pedal force, reduced pressure is generated in the rear chamber. |
![]() |
![]() |
![]() |
|
|