|
03-08-2023, 02:16 PM | #1 |
Junior Member
Join Date: Feb 2003
Location: P.Q.
Posts: 67
Likes: 1
Liked 1 Time in 1 Post
|
roller lifter
Hello! This is a sbc . New Jesel DLC coated pro-tie bar roller lifter .903 ,in Dart shp pro block with 55mm cam . I have an issue with the lifter .It Looks like it blocks the oil gallery off at Max lift .Has anyone noticed the same problem?
|
03-09-2023, 10:39 PM | #2 |
Member
Join Date: Mar 2013
Location: Italy, Texas
Posts: 143
Likes: 216
Liked 43 Times in 19 Posts
|
Re: roller lifter
Given how much time the lifter spends at max lift how would that cause any issues? Less oil to the top is a good thing.
|
Liked |
03-10-2023, 10:04 AM | #3 |
Junior Member
Join Date: Sep 2007
Location: Bucks Co Pa
Posts: 56
Likes: 16
Liked 14 Times in 10 Posts
|
Re: roller lifter
Base circle correct?
|
03-10-2023, 10:49 AM | #4 |
Junior Member
Join Date: Feb 2003
Location: P.Q.
Posts: 67
Likes: 1
Liked 1 Time in 1 Post
|
Re: roller lifter
|
03-10-2023, 02:06 PM | #5 |
Member
Join Date: Mar 2003
Posts: 180
Likes: 25
Liked 140 Times in 36 Posts
|
Re: roller lifter
A little line with a die grinder on the lifter oil hole will allow oil to flow, will not need much.
__________________
Dirk Olson 5036 STK |
Liked |
03-11-2023, 05:39 PM | #6 | |
Junior Member
Join Date: Feb 2003
Location: P.Q.
Posts: 67
Likes: 1
Liked 1 Time in 1 Post
|
Re: roller lifter
Quote:
There are few cheaper one that have the oil band well located. Thank you, |
|
03-14-2023, 08:40 AM | #7 |
Member
Join Date: Jun 2007
Location: NJ
Posts: 347
Likes: 54
Liked 126 Times in 60 Posts
|
Re: roller lifter
Did you call Jesel?
|
Liked |
03-14-2023, 05:04 PM | #8 |
Junior Member
Join Date: Feb 2003
Location: P.Q.
Posts: 67
Likes: 1
Liked 1 Time in 1 Post
|
Re: roller lifter
|
03-14-2023, 08:05 PM | #9 |
Junior Member
Join Date: Dec 2002
Location: Kalamazoo Michigan
Posts: 35
Likes: 1
Liked 5 Times in 4 Posts
|
Re: roller lifter
I have seen a few customers had the shop here mill a groove on each lifter. It doesn't need much, seems like it was only 3 thousands deep. Also a issue with Comp lifters and SBC dart block. If you don't groove them, keep a eye on the amount of oil under your valve covers............
|
Liked |
03-15-2023, 09:12 PM | #10 |
Junior Member
Join Date: Feb 2003
Location: P.Q.
Posts: 67
Likes: 1
Liked 1 Time in 1 Post
|
Re: roller lifter
|
|
|