Woodfin's SS GT/TB construction series

[Dragsinger]

More good news, the remaining needed parts are on the brown truck.

The next few weeks will be about updates to the package and plans to resume racing. The new package will sport a 4GC carb and move down one class to GT/TC.

[Dragsinger]

I like good looking welding, gives me a smile.

And I like views not usually seen. Next pics will have valves in place.

[Dragsinger]

YEA! Look what is out of storage and back in the shop

[Dragsinger]

The wiring is being completely revised. These are the "before"

[Dragsinger]

Saturday morning progress. Most electrical components remounted and ready for wiring runs.

[FireSale]

Originally Posted by Dragsinger

Saturday morning progress. Most electrical components remounted and ready for wiring runs.

Larry, is that a pre-wired relay board where you just plug in the switch and source wires? If so where did you get it? I have a small one that looks similar to clean up my electrical next off-season.

Electrical question: I have an MSD pill box like in your photo to trip my shift light. I want to be able to trip my light at my stage rpm and again at my shift point (currently 2800 and 5000 rpm). If I plug an MSD 2 or 3 Step into my current "pill box" will that work? I read the instructions at MSD but can't quite figure it out. It would be cheaper than a new level 2 or 3 shift light.

Dale

[Dragsinger]

Dale,

I will ponder your question and get back to you.

The relay board is part of the Digital Delay package that includes the dash switch controller that is also the dial-in display module. The dial-in showing on the switch panel is also showing on the outside mounted display board. It is a convenient package.

I will have it powered up soon and post photos.

Another relay/fuse board I use and like is "Nitrous Dave's Race Electronics" [or something close to that] He sells just the relay board to use with your switches. It is a good product and good value.

More soon.

[Mark Markow]

hey Larry in order for the g meter in your racepak to work properly. it has to be mounted flat and pointed in the direction of travel. standing it up like yours is not good.

[HandOverFist]

Set up for wheelstands?

[Dragsinger]

Mark, I knew that and forgot, Thanks for the reminder. Originally I had it mounted correctly but, "revised/improved" the mounting

I appreciate the catch and will change to "revision" three.