|
09-17-2020, 09:27 PM | #11 |
VIP Member
Join Date: Jun 2006
Posts: 3,349
Likes: 325
Liked 280 Times in 150 Posts
|
Re: carb
HSAB plugged or maybe you have the bowl gasket or metering plate gasket installed incorrectly OR you have the wrong gaskets to start with---a symptom of definitely siphoning fuel out
|
09-18-2020, 08:21 AM | #12 |
Senior Member
Join Date: Feb 2002
Location: Southeast Michigan
Posts: 885
Likes: 63
Liked 221 Times in 102 Posts
|
Re: carb
|
09-18-2020, 05:53 PM | #13 |
Member
Join Date: Mar 2006
Location: EL PASO, TEXAS
Posts: 156
Likes: 0
Liked 2 Times in 2 Posts
|
Re: carb
Question: Why would 2 seperate carburetors do the same thing
and the solution be a "plug'd" hi-speed air corrector be the answer? Technically doesn't make sense unless jim lives in the desert an he doesn't..... |
09-20-2020, 12:17 PM | #14 |
Junior Member
Join Date: Jun 2005
Location: Albert Lea, MN
Posts: 46
Likes: 2
Liked 16 Times in 7 Posts
|
Re: carb
Run leak down test on engine. Bet you'll find the problem
|
09-20-2020, 05:20 PM | #15 |
VIP Member
Join Date: Jun 2006
Posts: 3,349
Likes: 325
Liked 280 Times in 150 Posts
|
Re: carb
Not sure if you wrote "its solved" but you can run the engine up to about 2500RPM and put a gloved hand or towel over the carb top when the engine has almost died remove your hand or the towel and let the RPM come back up---do this 2-3 times and see if it clears up ---what you are doing is going from vacuum to siphoning and jostling any particles that may been the bleeds or the idle passages--kinda self cleaning or sloshing process by going back and forth
|
|
|