|
04-14-2015, 07:53 PM | #1 |
Junior Member
Join Date: Nov 2007
Posts: 7
Likes: 0
Liked 0 Times in 0 Posts
|
No trans brake in pro et
But I need trans brake for reverse. Anyway to make it work?
Thanks: J P |
04-15-2015, 09:45 AM | #2 |
VIP Member
Join Date: Feb 2006
Location: Dela-where?
Posts: 2,115
Likes: 1,004
Liked 1,641 Times in 520 Posts
|
Re: No trans brake in pro et
most use a simple toggle switch. I think at some northeast tracks it was allowed this way, out of normal drivers reach. lol
or you could put in a shifter switch that would only activate it in reverse
__________________
KEITH MAYERS 2 X somebody many X nobody |
04-15-2015, 11:59 PM | #3 |
Member
Join Date: Apr 2013
Location: Fabulous Las Vegas
Posts: 113
Likes: 28
Liked 21 Times in 12 Posts
|
Re: No trans brake in pro et
Just don't use it @ the line.
__________________
Jeff Dudgeon '66 Coronet #10771 - bracket puke "the Flying Brick" |
04-16-2015, 10:20 AM | #4 |
VIP Member
Join Date: Feb 2006
Location: Dela-where?
Posts: 2,115
Likes: 1,004
Liked 1,641 Times in 520 Posts
|
Re: No trans brake in pro et
As captain obvious stated, if you are not in the northeast, the electronics rules may not apply. here is what is allowed in div 1. (some tracks have their own policy)
Taken from the Northeast Division Schedule, Rules and Regulations: 17. Pro Eliminator (9.00-17.99) will be a NO-electronics class. Electronic ignition and single-stage (high side) rev-limiter will be accepted. Non-drive wheel line-locs will be accepted but wiring must be direct and traceable. Nitrous, must be activated by driver switch or wide open throttle switch, single stage only, no timers. Electronics expressly forbidden, but not limited to: data recorders, transbrakes, electric/automated shifters other than factory, two-steps, electronic throttle stops, and delay devices. Reverse Trans solenoid may only be operated by a switch affixed to the shifter, such as a back up light switch.
__________________
KEITH MAYERS 2 X somebody many X nobody Last edited by Keith 944; 04-16-2015 at 10:25 AM. |
Thread Tools | |
Display Modes | |
|
|