Q Jet Secoundary Rods - Page 2

Hacksaw · 06-07-2017, 11:16 AM

LL tip rods must be primary rods. I don't think anybody uses primary rods anymore in a race QJ.

monte385 · 06-07-2017, 12:07 PM

The largest tipped rod I've used in my street machine has been .052. Usually in the mid .040's to end up 12..5 -13.2 afr.

Jeff Stout · 06-07-2017, 12:54 PM

Here is what I did to measure hangers. Some with the same hanger letter measured differently.Put hanger on end of caliper and use the same drill bit and measure distance and record. If you look close to this hanger it shows as being cut. That made it adjustable. Just bend at cut and remeasure. I believe this hanger came with my first Hedworth carb back in 1991.

06-07-2017, 11:16 AM	#11
Hacksaw Senior Member Join Date: Sep 2016 Posts: 845 Likes: 151 Liked 277 Times in 152 Posts	Re: Q Jet Secoundary Rods LL tip rods must be primary rods. I don't think anybody uses primary rods anymore in a race QJ.

06-07-2017, 12:07 PM	#12
monte385 Junior Member Join Date: Oct 2015 Posts: 53 Likes: 34 Liked 19 Times in 16 Posts	Re: Q Jet Secoundary Rods The largest tipped rod I've used in my street machine has been .052. Usually in the mid .040's to end up 12..5 -13.2 afr.

06-07-2017, 12:54 PM	#13
Jeff Stout VIP Member Join Date: Dec 2001 Location: phoenix Posts: 1,426 Likes: 54 Liked 673 Times in 265 Posts	Re: Q Jet Secoundary Rods Here is what I did to measure hangers. Some with the same hanger letter measured differently.Put hanger on end of caliper and use the same drill bit and measure distance and record. If you look close to this hanger it shows as being cut. That made it adjustable. Just bend at cut and remeasure. I believe this hanger came with my first Hedworth carb back in 1991. Last edited by Jeff Stout; 06-07-2017 at 12:55 PM. Reason: more