Bracket Race Vehicle(s)

[1700camaro]

The plan was to race 2 events with multiple races at the end of Nov. Then we were going to pull the motor for time changes & a freshen up.

Plans change, with our race season starting in Jan. I decided not to race the end of the month & get the motor pulled. We've pre-ordered most of the hard parts & received some of them already. Hopefully this will help us for the start of the season.

We also ordered a new Holley Terminator X TBI EFI system, because my older Holley TBI EFI set-up is no longer supported. I have been busy transferring the old tune to the new software. Plus, we have to install/re-wire the new system in. The EFI expert(s) are saying there will be some differences when swapping the tune over. I hope it's minimal because the old tune was safe/conservative, competitive & ran high 8s 1/4 & 5.7s 1/8th on pump gas (100 UL).

We are planning to do a rear gear change also from a 3.89 to a 3.70 or 3.55 gear.

Don't know if I have enough time, but I want to convert the front AFCO shocks over to coilovers. Plus, I have to buy & change over the lower control arms.

Got a busy short off season to get this done & try to find time to test the drag quad.

1700/781L

[1700camaro]

Originally Posted by 1700camaro

The quad has recently been reconfigured for heads up 1/8th mile racing. Hoping to get some testing done this winter on it.

My son put a quad together last minute for a race earlier this year. The quad has no power adder but is on methanol. The below slip is one of the runs, it's a consistent 5.00 performer in the 1/8 mile.

While our quad will not be as fast as that, due to a hefty weight penalty; the chassis & my other son riding (280 lbs.). It will still be a quick ride. Looking forward to all the snide comments at the track. The most common one being "that's cute". My reply is always "wait till you see cute run"!

Who knows, I may even throw my leg over it & make some passes @ 62 years old.

1700/781L